Universal Flush Valve Toilet Repair Kit

Complete repair kit for button operated toilet cisterns

Code372686

Overview

Universal Flush Valve Toilet Repair Kit; the complete repair kit for button operated toilet cisterns.

Complete with:

~ Victoria Flush Valve with long life silicon rubber seal – now supplied with our NEW Valve Mate – retrofits: Dudley Victoria, FM Pro550 and WQ Kayla

~ Hydroflo Compact Brass Telescopic Bottom Inlet Valve

~ Contains all CC connections required to fully refurbish your cistern

Brochure

Features

  • Victoria Cable operation allows button to be located on front or top of cistern
  • Now supplied with our NEW Valve Mate - retrofits: Dudley Victoria, FM Pro550 and WQ Kayla
  • Attractive chrome plated pushbutton
  • Water saving full and reduced flush
  • Bayonet fixing enables valve body to be simply serviced in under five minutes
  • 290mm (11½”) cable length
  • Supplied with adaptor for 51mm (2”) outlet
  • 38mm (1½”) outlet
  • Hydroflo Compact Float will not catch on tight cistern installations where the inlet valve is close to the syphon or outlet valve, ensuring perfect operation
  • Telescopic height adjustment 203 (8”) - 292mm (11.5”)
  • Professional ½” brass tail
  • Water saving delay fill action
  • Patented integrated quiet fill action
  • The Cistern to Pan Bolt Sets includes all the nuts, bolts & washers required for connecting your cistern to the pan
  • Our Close Coupling Kits includes 1.1/2 cranked plate, nuts, bolts & 1.1/2” rubber doughnut washer

Frequently asked questions

Unfortunately, some of our cisterns are manufactured with the outlet spigot moulded in as part of the cistern body, and are used with a push fit flush pipe. In these cases, the Niagara pneumatic flushing valve that we use could only be replaced with another like for like Niagara flushing valve. If the cistern has a more conventional flushing valve fitted, connected to the cistern by a back nut, with a flush pipe connected by means of a cone ring and cap nut, then it would be possible to replace the existing flushing valve with other type of flushing valve.

Our current range of fully compliant Hydroflo inlet valves, come pre-fitted with a flow regulator, so no need for a flow restrictor. Our previous range were supplied with a flow restrictor, which needed to be removed for water pressures below 1.5 bar. As these inlet valves operate on an equilibrium principle, which uses the supply water pressure against itself to operate the valve they are suitable for use on water pressures between 0.1 bar and 14 bar.

If a Hydroflo inlet valve is not closing off, it may only need for the diaphragm washer and filter to be cleaned. Remove the large white nut attached to the float arm, This will give you access to the diaphragm washer, remove the washer, and clean with running water. To remove the filter, use the white key stored on top of the blue overhead discharge nozzle. This has a Bayonet fitting to help remove the filter unit. Clean the filter of any dirt and debris. Replace the cleaned filter and diaphragm washer, and re-assemble the unit

UK Stock Holding
Quality Assured
Fast and Efficient Delivery